DISASSEMBLY
Removal / installation · Vehicles built from Aug 2013
| 1. REMOVE STARTER YOKE ASSEMBLY |
Remove the nut and disconnect the lead wire from terminal C.

Remove the 2 bolts.
Pull out the starter yoke together with the starter armature from the magnet switch.
| 2. REMOVE MAGNET STARTER SWITCH ASSEMBLY |
Remove the 3 screws and magnet starter switch.

Remove the return spring, pinion gear, idler gear, clutch roller, retainer and starter clutch from the starter housing.

Text in Illustration *1
Return Spring
*2
Pinion Gear
*3
Idler Gear
*4
Clutch Roller
*5
Retainer
*6
Starter Clutch
*7
Starter Housing
Using a magnet hand, remove the steel ball from the clutch shaft hole.

Text in Illustration *1
Magnet Hand
| 3. REMOVE STARTER BRUSH HOLDER ASSEMBLY |
Disconnect the 4 starter yoke brushes from the starter brush holder.

Using a screwdriver, pull back the spring.
Disconnect the brush from the starter brush holder.
Remove the starter brush holder from the starter yoke.
Remove the O-ring.
| 4. REMOVE STARTER ARMATURE ASSEMBLY |
Place matchmarks on the starter yoke and commutator end frame.
Remove the starter armature together with the commutator end frame.
Remove the O-ring.
Using a plastic-faced hammer, tap the end frame to remove the starter armature from the commutator end frame.

