2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. INSTALL STARTER CLUTCH SUB-ASSEMBLY
  1. Apply high temperature grease to the steel ball, return spring, clutch roller, retainer, pinion gear and idler gear.

  1. A197147
    Insert the steel ball into the starter clutch hole.

  1. Insert the return spring into the starter clutch hole.

  1. A102601E01
    Install the starter clutch, return spring, idler gear, pinion gear, retainer and clutch roller.
    Text in Illustration 
    *1
    Return Spring
    *2
    Idler Gear
    *3
    Pinion Gear
    *4
    Clutch Roller
    *5
    Retainer
    *6
    Starter Clutch
    *7
    Starter Housing

  1. A102600
    Install the starter housing to the magnet starter switch with the 3 screws.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }


2. INSTALL STARTER ARMATURE ASSEMBLY

  1. A102618
    Apply high-temperature grease to the armature bearings.

  1. Using a press, press the armature into the commutator end frame.

  1. Install a new O-ring to the starter yoke.

  1. A102619E02
    Align the groove of the commutator end frame with the claw of the starter yoke, and install the armature and commutator end frame.
    Text in Illustration 
    *1
    Groove
    *2
    Claw


3. INSTALL STARTER BRUSH HOLDER ASSEMBLY

  1. A102620E02
    Align the claw of the starter brush holder with the groove of the starter yoke.
    Text in Illustration 
    *1
    Groove
    *2
    Claw

  1. Place the starter brush holder on the starter yoke.

  1. A102621
    Connect the 4 brushes to the starter brush holder.

    1. Using a screwdriver, pull back the spring.

    2. Connect the brush to the brush holder.

      NOTICE:
      Make sure that the positive (+) lead wires are not grounded.

  1. Install a new O-ring to the starter yoke.


4. INSTALL STARTER YOKE ASSEMBLY

  1. A102623E01
    Align the claw of the starter brush holder with the groove of the magnet starter switch and install the starter yoke to the magnet starter switch.
    Text in Illustration 
    *1
    Claw
    *2
    Groove

  1. Install the starter yoke to the starter housing with the 2 bolts.

    Torque:
    14 N*m{ 145 kgf*cm , 10 ft.*lbf }

  1. Connect the lead wire to terminal C with the nut.

    Torque:
    24 N*m{ 245 kgf*cm , 18 ft.*lbf }

← INSPECTION (from Aug 2013)INSTALLATION (Aug 2013 – Jul 2014) →