U0100/71 Lost Communication with ECM/PCM "A"
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Also covers:
- U0122/71 Lost Communication with Vehicle Dynamics Control Module
- U0124/71 Lost Communication with Lateral Acceleration Sensor Module
- U0126/71 Lost Communication with Steering Angle Sensor Module
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
| DTC Code |
DTC Detection Condition |
Trouble Area |
| U0100/71 |
While driving at 19 mph (30 km/h), the ECM indicates a CAN communication stop for 3 seconds or more. |
CAN communication system |
| U0122/71 |
The skid control ECU indicates a CAN communication stop for 3 seconds or more. |
CAN communication system |
| U0124/71 |
The yaw rate and acceleration sensor indicates a CAN communication stop for 3 seconds or more. |
CAN communication system |
| U0126/71 |
The steering angle sensor indicates a CAN communication stop for 3 seconds or more. |
CAN communication system |
INSPECTION PROCEDURE
| 1. CHECK DTC |
Clear the DTCs (Click here).
Perform a road test.
Check for DTCs (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output (for LHD with Entry and Start System)
B
DTC is output (for LHD without Entry and Start System)
C
DTC is output (for RHD with Entry and Start System)
D
DTC is output (for RHD without Entry and Start System)
E
- HINT:
- If a CAN communication malfunction DTC and a related sensor malfunction DTC are output at the same time, the CAN communication malfunction must be repaired before troubleshooting the sensor malfunction DTC.
|
|
||||
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||
