REMOVAL
Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for RHD and LHD vehicles.
| 1. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION |
![]() ![]() |
Detach the 5 clips and remove the No. 2 instrument panel finish panel cushion.
| 2. REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION |
- HINT:
- Use the same procedure described for the No. 2 instrument panel finish panel cushion.
| 3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH |
![]() ![]() |
Detach the 4 clips and remove the instrument panel finish panel end LH.
| 4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH |
![]() ![]() |
Detach the 4 clips and remove the instrument panel finish panel end RH.
| 5. REMOVE FRONT CONSOLE UPPER PANEL GARNISH |
w/o Seat Heater System:
Put protective tape around the front console upper panel garnish.

Text in Illustration *1
Protective Tape
Detach the 5 clips and remove the front console upper panel garnish.
Disconnect the connector.
w/o CRAWL:
Put protective tape around the front console upper panel garnish.

Text in Illustration *1
Protective Tape
Detach the 5 clips and remove the front console upper panel garnish.
Disconnect each connector.
w/ CRAWL:
Put protective tape around the front console upper panel garnish.

Text in Illustration *1
Protective Tape
Detach the 5 clips and remove the front console upper panel garnish.
| 6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission) |
![]() ![]() |
Move the shifting hole cover downward.
Text in Illustration *1
Shifting Hole Cover
Twist the shift lever knob in the direction indicated by the arrow and remove it.
| 7. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission) |
![]() ![]() |
Twist the shift lever knob in the direction indicated by the arrow and remove it.
| 8. REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission) |
![]() ![]() |
Put protective tape around the console panel.
Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 8 clips and 2 claws.
Disconnect each connector and remove the console panel.
| 9. REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) |
![]() ![]() |
Put protective tape around the console panel.
Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 8 clips and 2 claws.
Disconnect each connector and remove the console panel.
| 10. REMOVE INDOOR NO. 1 ELECTRICAL KEY ANTENNA ASSEMBLY |
Detach the clamp and remove the indoor No. 1 electrical key antenna assembly.

Text in Illustration *A
for Automatic Transmission
*B
for Manual Transmission







