2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT ELECTRIC EGR CONTROL VALVE ASSEMBLY

  1. A147237
    Inspect the electric EGR control valve.

    1. When a vacuum of 27 kPa (200 mmHg, 7.88 in.Hg) is applied to the diaphragm chamber, check that the shaft rises and air flows out.

    2. Maintaining the above conditions, check that there are no leaks and the shaft stays in position.

    3. Check that the valve does not have heavy carbon deposits and is not stuck.
      If the result is not as specified, replace the electric EGR control valve.

  1. Inspect the EGR valve position sensor.

    1. A085764E05
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (VC) - 2 (E2)
      20°C (68°F)
      4.0 to 6.0 kΩ

      Text in Illustration 
      *a
      Component without harness connected
      (Electric EGR Control Valve)
      If the result is not as specified, replace the electric EGR control valve assembly.

  1. Create a vacuum in the diaphragm chamber.

    1. A147238E03
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 (EGLS) - 2 (E2)
      20°C (68°F)
      EGR valve is fully opened
      2.0 to 7.0 kΩ
      20°C (68°F)
      EGR valve is fully closed
      0.1 to 2.5 kΩ

      Text in Illustration 
      *a
      Component without harness connected
      (Electric EGR Control Valve)

      HINT:
      The resistance increases in proportion to the opening angle of the EGR valve.

      If the result is not as specified, replace the electric EGR control valve assembly.


INSPECT NO. 2 EGR VALVE ASSEMBLY (w/ EGR Cooler)

  1. A147245
    When a vacuum of 33.3 kPa (250 mmHg, 9.83 in.Hg) is applied to the diaphragm chamber, check that the valve turns and air flows out.

  1. Maintaining the above conditions, check that there are no leaks and the valve does not return.

  1. Check that the valve does not have heavy carbon deposits and is not stuck.
    If the result is not as specified, replace the No. 2 EGR valve.

← REMOVAL (from Aug 2014)INSTALLATION (Aug 2013 – Jul 2014) →