ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2013
| CHECK RADIATOR RESERVOIR CAP SUB-ASSEMBLY |
Measure the valve opening pressure.

If there are water stains or foreign matter on O-ring 1, clean it with water and finger scouring.
Check that O-ring 1 is not deformed, cracked or swollen.
Apply engine coolant to O-ring 1 and rubber packing 2 before using a radiator cap tester.
When using the cap tester, tilt it more than 30°.

Text in Illustration *1
Radiator Cap
*2
Radiator Cap Tester
*a
More than 30°
Pump the cap tester several times, and then check the maximum pressure*.
- Pump speed:
- 1 pump per second
- Judgment Criterion:
Item
Specified Condition
Standard value
(for brand-new cap)
93 to 123 kPa (1.0 to 1.3 kgf/cm2, 13.5 to 18 psi)
Minimum standard value
(after using cap)
79 kPa (0.8 kgf/cm2, 11.4 psi)
| INSPECT FINS FOR BLOCKAGE |
If the fins are clogged, wash them with water or a steam cleaner and dry them with compressed air.
- NOTICE:
- To avoid damaging the fins, the injection direction should be at right angles to the core surface.
- If the steam cleaner is too close to the core, there is a possibility of damaging the fins, so maintain the following injection distances.
- Standard Injection Distance:
Injection Pressure
Specified Condition
2942 to 4903 kPa
(30.0 to 50.0 kgf/cm2, 427 to 711 psi)
300 mm (11.8 in.)
4903 to 7845 kPa
(50.0 to 80.0 kgf/cm2, 711 to 1138 psi)
500 mm (19.7 in.)
- If the fins are bent, straighten them with a screwdriver or pliers.
- Do not expose electronic components to water.
- To avoid damaging the fins, the injection direction should be at right angles to the core surface.
