Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering wheel (Click here).
HINT:
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
2.
REMOVE NO. 3 STEERING WHEEL LOWER COVER
Detach the 2 claws and remove the cover.
3.
REMOVE NO. 2 STEERING WHEEL LOWER COVER
Detach the 2 claws and remove the cover.
Text in Illustration
*A
w/o Cruise Control System
*B
w/ Cruise Control System
4.
REMOVE STEERING PAD ASSEMBLY
Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
Text in Illustration
*1
Screw Case
Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.
NOTICE:
When removing the steering pad, do not pull the airbag wire harness.
Disconnect the horn connector.
Disconnect the 2 connectors and remove the steering pad.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
5.
REMOVE STEERING WHEEL HEATER CONTROL ASSEMBLY
Disconnect the 2 connectors and connector clamp.
Remove the 2 screws and steering wheel heater control assembly.