2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY
  1. Disconnect the headlight cleaner washer motor and pump assembly connector.

    HINT:
    Make sure that the headlight cleaner washer motor and pump assembly is installed to the windshield washer jar assembly.

  1. Fill the windshield washer jar assembly with washer fluid.

  1. E197534E05
    Connect the positive (+) lead of the battery to terminal 2 of the headlight cleaner washer motor and pump assembly, and the negative (-) lead to terminal 1.

  1. Check that washer fluid flows from the windshield washer jar assembly.

    OK:
    Washer fluid flows from the windshield washer jar assembly.

    If the result is not as specified, replace the headlight cleaner motor and pump assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Headlight Cleaner Motor and Pump Assembly)

← REMOVAL (from Aug 2014)INSTALLATION (Aug 2013 – Jul 2014) →