2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. REMOVE UPPER RADIATOR SUPPORT SEAL
  1. Remove the 13 clips and upper radiator support seal.


2. REMOVE RADIATOR GRILLE

B357908E01
  1. Put protective tape around the radiator grille.

  1. Remove the 4 screws.

  1. Detach the 8 claws and remove the radiator grille.

    Text in Illustration 
    *1
    Protective Tape


3. REMOVE FRONT BUMPER COVER

  1. B353268
    Remove the 2 screws.

    HINT:
    Use the same procedure for the screws on the other side.

  1. B353353E01
    Remove the 2 screws.
    Text in Illustration 
    *1
    Screw
    *2
    Bolt A
    *3
    Bolt B

  1. Remove the 2 bolts labeled A and 2 bolts labeled B.

  1. B353270E01
    Put protective tape around the front bumper cover.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 4 clips.

  1. Detach the 16 claws and remove the front bumper cover.

    NOTICE:
    Do not hold the middle of the front bumper cover, as it may become reformed.

  1. w/ TOYOTA Parking Assist-sensor System, w/ Fog Light:
    Disconnect the 3 connectors.

  1. w/ TOYOTA Parking Assist-sensor System, w/o Fog Light:
    Disconnect the connector.

  1. w/o TOYOTA Parking Assist-sensor System, w/ Fog Light:
    Disconnect the 2 connectors.

  1. w/ Headlight Cleaner System:
    Disconnect the No. 1 headlight cleaner hose.


4. REMOVE HEADLIGHT CLEANER CONTROL RELAY

  1. E281672
    Disconnect the connector.

  1. Detach the claw and remove the headlight cleaner control relay.

← ON-VEHICLE INSPECTION (from Aug 2013)REMOVAL (from Aug 2014) →