2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. REMOVE UPPER RADIATOR SUPPORT SEAL
  1. Remove the 13 clips and upper radiator support seal.


2. REMOVE RADIATOR GRILLE

B357908E01
  1. Put protective tape around the radiator grille.

  1. Remove the 4 screws.

  1. Detach the 8 claws and remove the radiator grille.

    Text in Illustration 
    *1
    Protective Tape


3. REMOVE FRONT BUMPER COVER

  1. B353268
    Remove the 2 screws.

    HINT:
    Use the same procedure for the screws on the other side.

  1. B353353E01
    Remove the 2 screws.
    Text in Illustration 
    *1
    Screw
    *2
    Bolt A
    *3
    Bolt B

  1. Remove the 2 bolts labeled A and 2 bolts labeled B.

  1. B353270E01
    Put protective tape around the front bumper cover.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 4 clips.

  1. Detach the 16 claws and remove the front bumper cover.

    NOTICE:
    Do not hold the middle of the front bumper cover, as it may become reformed.

  1. w/ TOYOTA Parking Assist-sensor System, w/ Fog Light:
    Disconnect the 3 connectors.

  1. w/ TOYOTA Parking Assist-sensor System, w/o Fog Light:
    Disconnect the connector.

  1. w/o TOYOTA Parking Assist-sensor System, w/ Fog Light:
    Disconnect the 2 connectors.

  1. w/ Headlight Cleaner System:
    Disconnect the No. 1 headlight cleaner hose.


4. REMOVE FRONT WHEEL

5. REMOVE FRONT FENDER MUDGUARD RH

  1. E283294
    Remove the 2 clips.

  1. Remove the 4 screws and front fender mudguard RH.


6. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

  1. B366672
    Remove the screw.

  1. Remove the 13 grommets and front fender splash shield sub-assembly RH.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.


7. DRAIN WASHER FLUID

  1. E281644
    Disconnect the washer hose from the hose of the windshield washer motor and pump assembly, and then drain the washer fluid.

    HINT:
    Use a container to collect the washer fluid.


8. REMOVE WASHER INLET SUB-ASSEMBLY

  1. E197530
    Detach the claw and remove the washer inlet sub-assembly.


9. REMOVE WINDSHIELD WASHER JAR ASSEMBLY

  1. E198971
    w/o Headlight Cleaner System:
    Disconnect the connector.

  1. E281645
    w/ Headlight Cleaner System:
    Disconnect the 3 connectors.

  1. E281646
    Remove the 3 screws.

  1. E281647
    Detach the guide and remove the windshield washer jar assembly.


10. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
  1. Disconnect the connector.

  1. E281648
    Remove the windshield washer motor and pump assembly from the packing of the windshield washer jar assembly.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →