REMOVAL
Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. REMOVE UPPER RADIATOR SUPPORT SEAL |
Remove the 13 clips and upper radiator support seal.
| 2. REMOVE RADIATOR GRILLE |
![]() ![]() |
Put protective tape around the radiator grille.
Remove the 4 screws.
Detach the 8 claws and remove the radiator grille.
Text in Illustration *1
Protective Tape
| 3. REMOVE FRONT BUMPER COVER |
Remove the 2 screws.

- HINT:
- Use the same procedure for the screws on the other side.
Remove the 2 screws.

Text in Illustration *1
Screw
*2
Bolt A
*3
Bolt B
Remove the 2 bolts labeled A and 2 bolts labeled B.
Put protective tape around the front bumper cover.

Text in Illustration *1
Protective Tape
Remove the 4 clips.
Detach the 16 claws and remove the front bumper cover.
- NOTICE:
- Do not hold the middle of the front bumper cover, as it may become reformed.
w/ TOYOTA Parking Assist-sensor System, w/ Fog Light:
Disconnect the 3 connectors.
w/ TOYOTA Parking Assist-sensor System, w/o Fog Light:
Disconnect the connector.
w/o TOYOTA Parking Assist-sensor System, w/ Fog Light:
Disconnect the 2 connectors.
w/ Headlight Cleaner System:
Disconnect the No. 1 headlight cleaner hose.
| 4. DRAIN WASHER FLUID |
Disconnect the washer hose from the hose of the windshield washer motor and pump assembly, and then drain the washer fluid.

- HINT:
- Use a container to collect the washer fluid.
| 5. REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY |
Disconnect the 2 connectors.

Pull out the headlight cleaner motor and pump assembly in the direction indicated by the arrow in the illustration to remove it.


