2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. INSTALL HOOD SUPPORT ASSEMBLY LH

NOTICE:
  1. Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.
  2. Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.
  3. In order to prevent the piston rod from deforming, do not apply any horizontal load to the hood support.

  1. When reusing the hood support assembly:

    1. B238470
      Install the 2 stop rings to the hood support assembly.

  1. B238471
    Install the hood support assembly.

    NOTICE:
    Install the hood support assembly while supporting the hood by hand.

  1. Check that the hood support assembly is connected to the ball joint and cannot be pulled off.


2. INSTALL HOOD SUPPORT ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.


3. CONNECT WASHER HOSE ASSEMBLY

  1. B238463
    Attach the 4 clips and connect the washer hose assembly.


4. INSTALL WASHER NOZZLE SUB-ASSEMBLY
  1. Connect a new washer nozzle sub-assembly to the washer hose.

  1. Attach the 2 claws to install the washer nozzle sub-assembly.


5. INSPECT WASHER NOZZLE SUB-ASSEMBLY

  1. With the engine running, check the position that the washer fluid hits the windshield.

    Standard:
    Washer fluid hits the windshield in the areas shown in the illustration.


    E197817E01
    Text in Illustration 
    *1
    Ceramic Line
    -
    -
    *a
    Upper Limit
    *b
    Standard
    *c
    Lower Limit
    -
    -
    V100155
    Washer Fluid Spray Area
    -
    -

    Standard Clearance:
    Area
    Specified Condition
    Area
    Specified Condition
    A
    78 mm (3.07 in.)
    B
    213 mm (8.39 in.)
    C
    158 mm (6.22 in.)
    D
    124 mm (4.88 in.)

    HINT:
    If the result is not as specified, replace the malfunctioning washer nozzle sub-assembly.


6. INSTALL HOOD INSULATOR

  1. B238462
    Attach the 2 claws.

  1. Install the hood insulator with the 11 clips.


7. INSTALL HOOD TO RADIATOR SUPPORT SEAL
  1. Attach the 7 clips to install the hood to radiator support seal.


8. INSTALL FRONT HOOD MOULDING ASSEMBLY
  1. Install the front hood moulding with the 7 nuts.

← ADJUSTMENT (from Aug 2013)COMPONENTS (from Aug 2013) →