REPLACEMENT
Removal / installation · Vehicles built from Aug 2013
| 1. REPLACE STRAIGHT PIN |
- NOTICE:
- It is not necessary to remove a straight pin unless it is being replaced.


| *A |
Front Side |
*B |
Rear Side |
| *C |
Upper Side |
*D |
Lower Side |
Remove the straight pins.
Using a plastic-faced hammer, tap in new straight pins to the cylinder block.
- Standard Protrusion Height:
Item
Specified Condition
Pin A
22.5 to 23.5 mm (0.886 to 0.925 in.)
Pin B
10.5 to 11.5 mm (0.413 to 0.453 in.)
Pin C
8.5 to 9.5 mm (0.335 to 0.374 in.)
Pin D
5.5 to 6.5 mm (0.217 to 0.256 in.)
| 2. REPLACE CYLINDER BLOCK TIGHT PLUG |
- NOTICE:
- If coolant leaks from a tight plug or a plug is corroded, replace it.


| *A |
LH Side |
*B |
RH Side |
| *1 |
Standard Depth |
- |
- |
Remove the tight plugs.
Apply adhesive around new tight plugs.
- Adhesive:
- Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Using SST and a hammer, tap in the tight plugs to the standard depth.
- SST
- 09950-60010
(09951-00350)
09950-70010 (09951-07150)
- Standard depth:
- 0.2 to 1.2 mm (0.00787 to 0.0472 in.)
