2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

Generator Signal Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

When the engine is started, the generator assembly turns on and a voltage pulse signal is generated.
This signal is used by the air conditioning amplifier assembly.
The signal expressing the amount of output from the generator assembly is one element of PTC heater control.

WIRING DIAGRAM

E145301E29

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - GENERATOR)
  1. Disconnect the G25 amplifier connector.

  1. Disconnect the D3*1 or C65*2 generator connector.

    1. *1: for 1GR-FE
    2. *2: for 1KD-FTV

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for 1GR-FE 
    Tester Connection
    Condition
    Specified Condition
    G25-25 (ALT) - D3-3 (M)
    Always
    Below 1 Ω
    G25-25 (ALT) - Body ground
    Always
    10 kΩ or higher
    for 1KD-FTV 
    Tester Connection
    Condition
    Specified Condition
    G25-25 (ALT) - C65-3 (M)
    Always
    Below 1 Ω
    G25-25 (ALT) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Generator Signal Circuit (Aug 2013 – Jul 2014)IG Power Source Circuit (Aug 2013 – Jul 2014) →