2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT ENGINE SWITCH

  1. A129763E09
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (SS1) - 5 (GND)
    Pushed
    Below 1 Ω
    2 (SS2) - 5 (GND)
    Pushed
    Below 1 Ω
    7 (SS1) - 5 (GND)
    Not pushed
    10 kΩ or higher
    2 (SS2) - 5 (GND)
    Not pushed
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Engine Switch)
    If the result is not as specified, replace the engine switch.

  1. Apply battery voltage to the terminals of the switch and check the illumination condition of the switch.

    A109252E74

    Text in Illustration 
    *1
    Indicator Light
    -
    -
    *a
    Component without harness connected
    (Engine Switch)
    -
    -

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 11 (SWIL)
    Battery negative (-) → Terminal 5 (GND)
    Illuminates (illumination of lettering)
    Battery positive (+) → Terminal 12 (INDS)
    Battery negative (-) → Terminal 5 (GND)
    Illuminates (green)
    Battery positive (+) → Terminal 13 (INDW)
    Battery negative (-) → Terminal 5 (GND)
    Illuminates (amber)

    NOTICE:
    1. If the positive (+) lead and negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
    2. If the voltage is too low, the indicator will not illuminate.

    If the result is not as specified, replace the engine switch.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →