2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. INSTALL UNLOCK WARNING SWITCH ASSEMBLY

  1. If reusing the unlock warning switch assembly:

    1. B239932E01
      Install the unlock warning switch.
      Text in Illustration 
      *1
      Pin Cap
      V100135
      Slide

    2. Install the pin cap.

    3. B239930
      Connect the unlock warning switch connector.

    4. Attach the 3 claws to install the cover.

  1. B239933E01
    If replacing the unlock warning switch assembly:
    Text in Illustration 
    *1
    Pin
    V100135
    Slide

    1. While pushing the pin, slide the switch to install the warning switch.

    2. B239934
      Connect the unlock warning switch connector.


2. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
  1. Attach the claw to install the windshield wiper switch assembly.

  1. w/ Rain Sensor:
    Connect the connector.

  1. w/o Rain Sensor:
    Connect the 2 connectors.


3. INSTALL UPPER STEERING COLUMN COVER
  1. Attach the 4 clips to install the upper steering column cover to the instrument cluster finish panel.


4. INSTALL LOWER STEERING COLUMN COVER
  1. Attach the 2 claws to install the lower steering cover.

  1. for Power Tilt and Power Telescopic:
    Install the screw.

  1. Turn the steering wheel to the right and left as necessary to install the 2 screws.

← INSPECTION (from Aug 2013)COMPONENTS (from Aug 2013) →