2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE LOWER STEERING COLUMN COVER

  1. E198970
    Turn the steering wheel to the left as necessary to remove the screw.

  1. E198974
    Turn the steering wheel to the right as necessary to remove the screw.

  1. E202443
    for Power Tilt and Power Telescopic:

    1. Remove the screw.

  1. B243928
    Detach the 2 claws and remove the lower steering column cover.


3. REMOVE UPPER STEERING COLUMN COVER

  1. E202160
    Detach the 4 clips and claw to remove the upper steering column cover.


4. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

  1. E202158
    w/ Rain Sensor:
    Disconnect the connector.

  1. E202159
    w/o Rain Sensor:
    Disconnect the 2 connectors.

  1. Detach the claw and remove the windshield wiper switch assembly.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →