2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT REAR HEADER SPEAKER ASSEMBLY

  1. E180661E16
    for Pioneer Made:

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Always
      4 Ω

      If the result is not as specified, replace the rear header speaker assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Rear Header Speaker Assembly)

  1. for JBL Made:
    When there is a malfunction such as noise from a speaker or no sound at all, replace the speaker with a new one and check that the malfunction disappears.

    OK:
    Malfunction disappears.

    HINT:
    1. Connect the connectors to the rear header speakers.
    2. When there is a possibility that either the right or left rear header speaker assembly is defective, inspect by interchanging the right one with the left one.
    3. Perform the inspection above on both the LH and RH sides.


INSPECT NO. 1 SPEAKER ASSEMBLY WITH BOX

  1. for Pioneer Made:

    1. E180660E46
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (WF1+) - 3 (WF1-)
      Always
      2 Ω

      If the result is not as specified, replace the No. 1 speaker assembly with box.
      Text in Illustration 
      *a
      Component without harness connected
      (No. 1 Speaker Assembly with Box)

  1. for JBL Made:

    1. E180660E47
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (WF1+) - 2 (WF2+)
      Always
      1.6 to 2.4 Ω
      3 (WF1-) - 4 (WF2-)
      Always
      1.6 to 2.4 Ω

      If the result is not as specified, replace the No. 1 speaker assembly with box.
      Text in Illustration 
      *a
      Component without harness connected
      (No. 1 Speaker Assembly with Box)

← REMOVAL (from Aug 2014)INSTALLATION (Aug 2013 – Jul 2014) →