INSPECTION
Inspection · Vehicles built from Aug 2013
| INSPECT TRANSMISSION CONTROL SWITCH |
![]() ![]() |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
3 (IG) - 7 (S)
Shift lever in S, "+" or "-"
Below 1 Ω
3 (IG) - 7 (S)
Shift lever not in S, "+" or "-"
10 kΩ or higher
If the result is not as specified, replace the transmission floor shift assembly.Text in Illustration *a
Component without harness connected
(Transmission Control Switch)


