2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT TRANSMISSION FLOOR SHIFT ASSEMBLY (SHIFT LOCK CONTROL ECU)

C214921E01
  1. Measure the voltage and resistance according to the value(s) in the table below.

    HINT:
    Do not disconnect the shift lock control ECU connector.

    Standard Voltage and Resistance:
    Tester Connection
    Condition
    Specified Condition
    G34-6 (ACC) - G34-8 (E)
    Ignition switch ON
    11 to 14 V
    G34-6 (ACC) - G34-8 (E)
    Ignition switch ACC
    11 to 14 V
    G34-6 (ACC) - G34-8 (E)
    Ignition switch off
    Below 1 V
    G34-7 (STP) - G34-8 (E)
    Brake pedal depressed
    11 to 14 V
    G34-7 (STP) - G34-8 (E)
    Brake pedal released
    Below 1 V
    G34-12 (KLS+) - G34-8 (E)
    1. Ignition switch ACC and shift lever in P
    Below 1 V
    2. Ignition switch ACC and shift lever not in P (Within approx. 1 second)
    7.5 to 11 V
    3. Ignition switch ACC and shift lever not in P (After approx. 2 seconds)
    6 to 9.5 V
    G34-1 (IG) - G34-8 (E)
    Ignition switch ON
    11 to 14 V
    G34-1 (IG) - G34-8 (E)
    Ignition switch off
    Below 1 V
    G34-8 (E) - Body ground
    Always
    Below 1 Ī©

    Text in IllustrationĀ 
    *a
    Component with harness connected
    (Shift Lock Control ECU)
    If the result is not as specified, replace the transmission floor shift assembly.

← REMOVAL (from Aug 2014)ADJUSTMENT (from Aug 2013) →