Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
DESCRIPTION
When 2nd start mode is selected with the pattern select (2ND) switch, the ECM controls the solenoid valves and the transmission starts from 2nd gear. In 2nd start mode, the system operates the throttle motor to control engine output to reduce skidding of the drive wheels and guarantee stable acceleration from rest, straight driving and turning stability. When the shift lever is in D, the transmission automatically shifts up from 2nd to 4th as usual.
HINT:
The pattern select (2ND) switch is a momentary-type switch.
In order to cancel 2nd start mode, push the pattern select (2ND) switch again or turn the ignition switch off.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. INSPECT PATTERN SELECT (2ND) SWITCH ASSEMBLY
Remove the pattern select (2ND) switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
1 (E) - 4 (2ND)
Pattern select (2ND) switch pushed
Below 1 Ω
1 (E) - 4 (2ND)
Pattern select (2ND) switch not pushed
10 kΩ or higher
Text in Illustration
*a
Component without harness connected (Pattern Select (2ND) Switch Assembly)