C1428 Motor Circuit Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1428 |
With the motor relay off and the motor fail-safe relay on, an open in the motor circuit continues for 2 seconds or more. |
Brake actuator assembly (Motor circuit) |
WIRING DIAGRAM
Refer to DTCs C0273, C0274 and C1361 (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform zero point calibration (Click here).
| 1. CHECK HARNESS AND CONNECTOR (GND2 TERMINAL) |
Disconnect the A6 skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A6-13 (GND2) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
