2013-2015 Land Cruiser Prado · Service Manual Brake

C1428 Motor Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
C1428
With the motor relay off and the motor fail-safe relay on, an open in the motor circuit continues for 2 seconds or more.
Brake actuator assembly (Motor circuit)

WIRING DIAGRAM

Refer to DTCs C0273, C0274 and C1361 (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).


1. CHECK HARNESS AND CONNECTOR (GND2 TERMINAL)
  1. Disconnect the A6 skid control ECU (brake actuator assembly) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A6-13 (GND2) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← C1428 Motor Circuit Malfunction (Aug 2013 – Jul 2014)C1429 Open or Short in Brake Pedal Load Sensing Switch (Aug 2013 – Jul 2014) →