2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSTALL NO. 2 BACK DOOR STIFFENER

HINT:
Use the same procedure to install the No. 2 back door stiffener on the other side.

  1. Attach the 2 claws to install a new No. 2 back door stiffener.


2. INSTALL REAR SPOILER SUB-ASSEMBLY
  1. Attach the 3 clips to install the rear spoiler.

  1. Install the 6 bolts and 2 grommets.

  1. Connect the connector.


3. INSTALL REAR SPOILER COVER RH
  1. Attach the 2 clips to install the rear spoiler cover.


4. INSTALL BACK DOOR SIDE GARNISH LH
  1. Attach the 2 clips and claw to install the back door side garnish.


5. INSTALL BACK DOOR SIDE GARNISH RH
  1. Attach the 2 clips and claw to install the back door side garnish.


6. INSTALL CENTER BACK DOOR GARNISH
  1. Attach the 4 clips to install the back door center garnish.

← REASSEMBLY (from Aug 2013)COMPONENTS (from Aug 2013) →