2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE ROOF RACK ASSEMBLY LH (w/ Roof Rack)
  1. Remove the roof rack (Click here).


2. REMOVE ROOF DRIP SIDE FINISH MOULDING JOINT COVER LH (w/o Roof Rack)

B236283E01

HINT:
Use the same procedure to remove the roof drip side finish moulding joint cover on the other side.

  1. Put protective tape around the roof drip side finish moulding joint cover.

  1. Detach the 2 claws and remove the roof drip side finish moulding joint cover.

    Text in Illustration 
    *1
    Protective Tape


3. REMOVE ROOF DRIP SIDE FINISH MOULDING LH

B236279E01
  1. Put protective tape around the roof drip side finish moulding.

  1. Detach the clip and remove the roof drip side finish moulding.

    NOTICE:
    1. When removing the rear roof drip side finish moulding, be careful not to damage the roof drip side finish moulding clip.
    2. If the roof drip side finish moulding clip is damaged or becomes detached from the vehicle, replace it with a new one.

    Text in Illustration 
    *1
    Protective Tape


4. REMOVE CENTER NO. 2 ROOF DRIP SIDE FINISH MOULDING LH

B236280E01
  1. Put protective tape around the center No. 2 roof drip side finish moulding.

  1. Remove the center No. 2 roof drip side finish moulding.

    Text in Illustration 
    *1
    Protective Tape


5. REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING LH

B236281E01
  1. Put protective tape around the center roof drip side finish moulding.

  1. Remove the center roof drip side finish moulding.

    Text in Illustration 
    *1
    Protective Tape


6. REMOVE REAR ROOF DRIP SIDE FINISH MOULDING LH

B236282E01
  1. Put protective tape around the rear roof drip side finish moulding.

  1. Detach the clip and remove the rear roof drip side finish moulding.

    NOTICE:
    1. When removing the rear roof drip side finish moulding, be careful not to damage the roof drip side finish moulding clip.
    2. If the roof drip side finish moulding clip is damaged or becomes detached from the vehicle, replace it with a new one.

    Text in Illustration 
    *1
    Protective Tape

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →