INSTALLATION
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY |
Attach the 4 clips to install the back door outside garnish.
Install the 4 nuts.
Connect the connector.
| 2. INSTALL BACK DOOR OUTSIDE HANDLE LH |
w/ Back Door Tire Carrier:
Connect the cable.

Install the back door outside handle with the 2 nuts.
- Torque:
- 5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
Install the hole plug.
Text in Illustration *1
Hole Plug
w/o Back Door Tire Carrier:
Connect the cable.

Install the back door outside handle with the 2 nuts.
- Torque:
- 5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
| 3. INSTALL BACK DOOR SERVICE HOLE COVER |
Apply new butyl tape to the back door panel.

Attach the rear door service hole cover using to the reference points on the rear door panel.
Text in Illustration *1
Reference Point
- NOTICE:
- There should be no wrinkles or folds after attaching the service hole cover.
- After attaching the service hole cover, check the seal quality.
- There should be no wrinkles or folds after attaching the service hole cover.
| 4. INSTALL BACK DOOR INSIDE HANDLE SUB-ASSEMBLY (for Face to Face Seat Type) |
Connect the 2 cables to the inside handle sub-assembly.

Attach the claws and guide to install the inside handle sub-assembly.
| 5. INSTALL BACK DOOR TRIM PANEL ASSEMBLY |
w/o Back Door Tire Carrier:
Attach the 15 clips to install the back door trim panel assembly.
Install the bolt.
w/ Back Door Tire Carrier:
Attach the 16 clips to install the back door trim panel assembly.
Install the bolt.
for Face to Face Seat Type:
Attach the 15 clips to install the back door trim panel assembly.
Install the bolt.
Install the screw.
Attach the claw to install the cover.
| 6. INSTALL BACK DOOR INSIDE HANDLE BEZEL (for Face to Face Seat Type) |
Attach the 5 claws to install the back door inside handle bezel.
Install the screw.
| 7. INSTALL TOOL CASE |
Attach the 2 claws to install the tool case.
| 8. INSTALL UPPER TOOL BOX PANEL SUB-ASSEMBLY |
Attach the 3 claws.

Install the upper tool box panel sub-assembly as shown in the illustration.
| 9. INSTALL BACK DOOR TRIM COVER |
Attach the 4 claws.

Install the back door trim cover as shown in the illustration.
| 10. INSTALL BACK DOOR SIDE GARNISH LH |
Attach the 2 clips and claw to install the back door side garnish.
| 11. INSTALL BACK DOOR SIDE GARNISH RH |
Attach the 2 clips and claw to install the back door side garnish.
| 12. INSTALL CENTER BACK DOOR GARNISH |
Attach the 4 clips to install the back door center garnish.
