2013-2015 Land Cruiser Prado · Service Manual Suspension

PRECAUTION

Precautions · Vehicles built from Aug 2013


1.IGNITION SWITCH EXPRESSION
  1. The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression
    Ignition Switch (Position)
    Engine Switch (Condition)
    Ignition Switch off
    LOCK
    Off (Lock)
    Ignition Switch ACC
    ACC
    On (ACC)
    Ignition Switch ON
    ON
    On (IG)
    Engine Start
    START
    On (Start)


2.KINETIC DYNAMIC SUSPENSION SYSTEM

CAUTION:
  1. Be sure to check the pipe connections and whether or not any hydraulic circuit parts are damaged before performing work, as the hydraulic circuits become highly pressurized during air bleeding.
  2. The pipes become highly pressurized when bleeding air. If a fluid leak is discovered, immediately release the pressure and repair the fluid leak as there is danger involved.

  1. Before removing, installing and disassembling hydraulic circuit parts, clean each part to prevent mud and dirt from entering the hydraulic circuit.

  2. Always drain fluid from the bleeder plug of the stabilizer control housing to reduce pressure before removing parts, as the fluid is sealed under high pressure in the hydraulic circuit.

  3. Protect the removed/disassembled parts with plastic bags to prevent foreign matter from adhering to or entering them, and store them in a safe place.

  4. Be careful when removing, installing and disassembling the hydraulic circuit related parts, such as bleeder plugs and tube flare nuts, as fluid may leak when the parts are damaged.

← U0100/71 Lost Communication with ECM/PCM "A" (+ 5 more codes) (from Aug 2014)PARTS LOCATION (from Aug 2013) →