2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT CENTER CLUSTER MODULE SWITCH (CENTER DIFFERENTIAL LOCK SWITCH)

  1. C281308E04
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (CPU) - 24 (E)
    ON
    Below 1 Ω
    OFF
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Center Cluster Module Switch (Center Differential Lock Switch))
    If the result is not as specified, replace the center cluster module switch (center differential lock switch).

  1. C293184E01
    Apply battery voltage between the terminals of the switch, and check the illumination condition of the center cluster module switch (center differential lock switch).

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 13 (ILL+)
    Battery negative (-) → 12 (ILL-)
    Illuminates

    Text in Illustration 
    *a
    Component without harness connected
    (Center Cluster Module Switch (Center Differential Lock Switch))
    *b
    Center Cluster Module Switch (Center Differential Lock Switch) Illumination
    If the result is not as specified, replace the center cluster module switch (center differential lock switch).

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →