2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
  1. Attach the 7 claws and 2 guides to install the No. 3 instrument panel register assembly.


2. INSTALL NO. 2 RADIO RECEIVER BRACKET
  1. Install the No. 2 radio receiver bracket with the 3 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


3. INSTALL NO. 1 RADIO RECEIVER BRACKET
  1. Install the No. 1 radio receiver bracket with the 3 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


4. INSTALL HAZARD SWITCH WIRE
  1. Attach the clamp to install the hazard switch wire.


5. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY
  1. Attach the 2 claws to install the hazard warning signal switch assembly.

  1. Connect the connector.


6. INSTALL NAVIGATION RECEIVER ASSEMBLY
  1. Connect each connector.

  1. B358816
    Insert the navigation receiver assembly and attach the 7 clips on the backside of the navigation receiver assembly.

    NOTICE:
    When inserting the receiver, do not press the knobs on it.

  1. Install the navigation receiver assembly with the 4 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }


7. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY
  1. Connect the connector.

  1. Attach the 4 clips to install the integration control and panel assembly.


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← REMOVAL (from Aug 2014)INSTALLATION (from Aug 2014) →