Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
HINT:
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.
PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
3.
REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY
Detach the 4 clips.
Disconnect the connector and remove the integration control and panel assembly.
4.
REMOVE NAVIGATION RECEIVER ASSEMBLY
Remove the 4 bolts.
Pull the navigation receiver assembly to detach the 7 clips on the backside of the navigation receiver assembly.
Disconnect each connector and remove the navigation receiver assembly.
5.
REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY
Disconnect the connector.
Using a screwdriver, detach the 2 claws and remove the hazard warning signal switch assembly.
6.
REMOVE HAZARD SWITCH WIRE
Detach the clamp and remove the hazard switch wire.
7.
REMOVE NO. 1 RADIO RECEIVER BRACKET
Remove the 3 screws and No. 1 radio receiver bracket.
8.
REMOVE NO. 2 RADIO RECEIVER BRACKET
Remove the 3 screws and No. 2 radio receiver bracket.