2013-2015 Land Cruiser Prado · Service Manual Brake

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT CRAWL CONTROL SWITCH

  1. C291792E01
    C281308E01
    Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    LO
    *b
    LO / MEDIUM
    *c
    MEDIUM
    *d
    MEDIUM / HI
    *e
    HI

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    17 (ECU) - 24 (E)
    LO
    Below 1 Ω
    18 (UP) - 24 (E)
    19 (DN) - 24 (E)
    10 kΩ or higher
    17 (ECU) - 24 (E)
    LO / MEDIUM
    Below 1 Ω
    18 (UP) - 24 (E)
    10 kΩ or higher
    19 (DN) - 24 (E)
    17 (ECU) - 24 (E)
    MEDIUM
    10 kΩ or higher
    18 (UP) - 24 (E)
    19 (DN) - 24 (E)
    17 (ECU) - 24 (E)
    MEDIUM / HI
    10 kΩ or higher
    18 (UP) - 24 (E)
    19 (DN) - 24 (E)
    Below 1 Ω
    17 (ECU) - 24 (E)
    HI
    10 kΩ or higher
    18 (UP) - 24 (E)
    Below 1 Ω
    19 (DN) - 24 (E)
    21 (FRB) - 24 (E)
    ON/OFF: Pressed
    Below 1 Ω
    ON/OFF: Not pressed
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Center Cluster Module switch (Crawl Control Switch))
    If the result is not as specified, replace the crawl control switch.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →