REMOVAL
Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for RHD and LHD vehicles.
| 1. REMOVE DOOR SCUFF PLATE ASSEMBLY RH |
- HINT:
- Use the same procedure described for the LH side.
| 2. REMOVE COWL SIDE TRIM BOARD RH |
- HINT:
- Use the same procedure described for the LH side.
| 3. REMOVE INSTRUMENT SIDE PANEL RH |
![]() ![]() |
Put protective tape around the instrument side panel.
Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 5 clips, claw, and 3 guides.
Disconnect the connector and remove the instrument side panel.
| 4. REMOVE INSTRUMENT PANEL ORNAMENT |
![]() ![]() |
Put protective tape around the instrument panel ornament.
Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 5 clips and remove the instrument panel ornament.
| 5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Remove the screw.
Detach the 3 clips and 2 guides and remove the No. 2 instrument panel under cover.


Text in Illustration *A
for LHD
*B
for RHD
| 6. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY |
![]() ![]() |
Remove the 2 bolts <C> and 2 screws <A> or <B>.
Text in Illustration *1
Bolt
*2
Screw
Detach the 5 clips and claw.
Disconnect each connector and remove the glove compartment door.
| 7. REMOVE DOUBLE LOCK DOOR CONTROL RELAY ASSEMBLY |
Disconnect the connector.

Remove the nut and double lock door control relay.



