2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL QUARTER PANEL PLATE

B268497E01

HINT:
When installing the quarter panel plate, heat the vehicle body and quarter panel plate using a heat light.

Standard Heating Temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Quarter Panel Plate
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or quarter panel plate excessively.

  1. Clean the vehicle body surface.

    1. Using a heat light, heat the vehicle body surface.

    2. Remove the double-sided tape from the vehicle body.

    3. Wipe off any tape adhesive residue with cleaner.

  1. Install a new quarter panel plate.

    1. Using a heat light, heat the vehicle body and a new quarter panel plate.

    2. Remove the peeling paper from the face of the quarter panel plate.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    3. Install the quarter panel plate in the position shown in the illustration.

      HINT:
      Press the quarter panel plate firmly to install it.

      Text in Illustration 
      *A
      for 5 Door
      *B
      for 3 Door
      *a
      Reference Values
      *b
      Imaginary line extending from bottom edge of quarter window glass.

← REMOVAL (from Aug 2013)COMPONENTS (from Aug 2013) →