2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REPAIR

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Bore all 4 cylinders to fit the O/S piston outside diameter.
  2. Replace all the piston rings with ones to match the O/S pistons.


1. BORE CYLINDER
  1. Prepare 4 new O/S pistons.

  1. G037359E04
    Using a micrometer, measure the piston diameter at right angles to the piston center line where the distance from the piston end is as specified.

    Standard piston diameter (O/S 0.50):
    95.441 to 95.471 mm (3.758 to 3.759 in.)

    Distance:
    13.8 mm (0.543 in.)

    Text in Illustration 
    *1
    Distance

  1. Calculate the amount each cylinder is to be rebored as follows.

    HINT:
    1. Size to be rebored = P + C - H
      P = Piston diameter
      C = Piston oil clearance: 0.013 to 0.036 mm (0.000512 to 0.00142 in.)
      H = Allowance for honing: 0.02 mm (0.000787 in.) or less

  1. Bore and hone the cylinders to the calculated dimensions.

    NOTICE:
    Excess honing will destroy the finished roundness.

  1. Using a cylinder gauge, measure the cylinder bore diameter and calculate the honing allowance.

    HINT:
    Honing allowance = cylinder bore diameter - (piston diameter + oil clearance)

  1. Finish the cylinder bore using the calculated value.

  1. A101487E02
    Using a cylinder gauge, measure the cylinder bore diameter.

    Standard oil clearance:
    0.019 to 0.052 mm (0.000748 to 0.00205 in.)

    Text in Illustration 
    *1
    Thrust Direction
    *2
    Axial Direction
    V100135
    Front

← REASSEMBLY (from Aug 2013)PRECAUTION (Aug 2013 – Jul 2014) →