C1AEC Front Sensor Communication Malfunction
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This DTC is stored when there is an open or short circuit in the communication line between the front sensors and ECU, or when there is a malfunction in a front sensor.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1AEC |
An open or short circuit in the communication line between the front sensors and ECU or a malfunction in a front sensor during initialization mode after the engine switch is turned on (IG). |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
Result Result
Proceed to
No DTC is output
A
DTC C1AEC is output
B
|
|
||||
| A | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - FRONT CORNER SENSOR LH) |
Disconnect the G154 clearance warning ECU connector.
Disconnect the B7 No. 1 ultrasonic sensor (front corner sensor LH) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G154-21 (BOF) - B7-1 (BI)
Always
Below 1 Ω
G154-9 (SOF) - B7-3 (SI)
Always
Below 1 Ω
G154-19 (E1) - B7-5 (EI)
Always
Below 1 Ω
G154-21 (BOF) - Body ground
Always
10 kΩ or higher
G154-9 (SOF) - Body ground
Always
10 kΩ or higher
G154-19 (E1) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (FRONT CORNER SENSOR LH - FRONT CENTER SENSOR LH) |
Disconnect the B7 No. 1 ultrasonic sensor (front corner sensor LH) connector.
Disconnect the B8 No. 1 ultrasonic sensor (front center sensor LH) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
B7-2 (BO) - B8-1 (BI)
Always
Below 1 Ω
B7-4 (SO) - B8-3 (SI)
Always
Below 1 Ω
B7-6 (EO) - B8-5 (EI)
Always
Below 1 Ω
B7-2 (BO) - Body ground
Always
10 kΩ or higher
B7-4 (SO) - Body ground
Always
10 kΩ or higher
B7-6 (EO) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (FRONT CENTER SENSOR LH - FRONT CENTER SENSOR RH) |
Disconnect the B8 No. 1 ultrasonic sensor (front center sensor LH) connector.
Disconnect the B9 No. 1 ultrasonic sensor (front center sensor RH) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
B8-2 (BO) - B9-1 (BI)
Always
Below 1 Ω
B8-4 (SO) - B9-3 (SI)
Always
Below 1 Ω
B8-6 (EO) - B9-5 (EI)
Always
Below 1 Ω
B8-2 (BO) - Body ground
Always
10 kΩ or higher
B8-4 (SO) - Body ground
Always
10 kΩ or higher
B8-6 (EO) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (FRONT CENTER SENSOR RH - FRONT CORNER SENSOR RH) |
Disconnect the B9 No. 1 ultrasonic sensor (front center sensor RH) connector.
Disconnect the B10 No. 1 ultrasonic sensor (front corner sensor RH) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
B9-2 (BO) - B10-1 (BI)
Always
Below 1 Ω
B9-4 (SO) - B10-3 (SI)
Always
Below 1 Ω
B9-6 (EO) - B10-5 (EI)
Always
Below 1 Ω
B9-2 (BO) - Body ground
Always
10 kΩ or higher
B9-4 (SO) - Body ground
Always
10 kΩ or higher
B9-6 (EO) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 6. INSPECT NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR LH) |
Remove the No. 1 ultrasonic sensor (front corner sensor LH) (Click here).
Inspect the No. 1 ultrasonic sensor (front corner sensor LH) (Click here).
|
|
||||
| OK | |
| 7. INSPECT NO. 1 ULTRASONIC SENSOR (FRONT CENTER SENSOR LH) |
Remove the No. 1 ultrasonic sensor (front center sensor LH) (Click here).
Inspect the No. 1 ultrasonic sensor (front center sensor LH) (Click here).
|
|
||||
| OK | |
| 8. INSPECT NO. 1 ULTRASONIC SENSOR (FRONT CENTER SENSOR RH) |
Remove the No. 1 ultrasonic sensor (front center sensor RH) (Click here).
Inspect the No. 1 ultrasonic sensor (front center sensor RH) (Click here).
|
|
||||
| OK | |
| 9. REPLACE NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR RH) |
Replace the No. 1 ultrasonic sensor (front corner sensor RH) with a normally functioning sensor (Click here).
| NEXT | |
| 10. CHECK FOR DTC (C1AEC) |
Clear the DTCs (Click here).
Check for DTCs (Click here).
Result Result
Proceed to
No DTC is output
A
DTC C1AEC is output
B
|
|
||||
| A | ||
| ||
| 11. REPLACE NO. 1 ULTRASONIC SENSOR (FRONT CENTER SENSOR LH) |
Replace the No. 1 ultrasonic sensor (front center sensor LH) with a normally functioning sensor (Click here).
- HINT:
- All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
| NEXT | |
| 12. CHECK FOR DTC (C1AEC) |
Clear the DTCs (Click here).
Check for DTCs (Click here).
Result Result
Proceed to
No DTC is output
A
DTC C1AEC is output
B
|
|
||||
| A | ||
| ||
| 13. REPLACE NO. 1 ULTRASONIC SENSOR (FRONT CENTER SENSOR RH) |
Replace the No. 1 ultrasonic sensor (front center sensor RH) with a normally functioning sensor (Click here).
- HINT:
- All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
| NEXT | |
| 14. CHECK FOR DTC (C1AEC) |
Clear the DTCs (Click here).
Check for DTCs (Click here).
Result Result
Proceed to
No DTC is output
A
DTC C1AEC is output
B
|
|
||||
| A | ||
| ||
| 15. REPLACE NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR LH) |
Replace the No. 1 ultrasonic sensor (front corner sensor LH) with a normally functioning sensor (Click here).
- HINT:
- All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
| NEXT | |
| 16. CHECK FOR DTC (C1AEC) |
Clear the DTCs (Click here).
Check for DTCs (Click here).
Result Result
Proceed to
No DTC is output
A
DTC C1AEC is output (for LHD)
B
DTC C1AEC is output (for RHD)
C
|
|
||||
|
|
||||
| A | ||
| ||
