2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT ENGINE OIL LEVEL
  1. Warm up the engine, stop the engine and wait 5 minutes.

  1. Check that the oil level is between the dipstick low level mark and full level mark.
    If the level is low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill engine oil above the full level mark.


INSPECT ENGINE OIL QUALITY
  1. Check the oil for deterioration, water contamination, discoloration or thinning. If the quality is visibly poor, replace the oil and filter (Click here).


INSPECT OIL PRESSURE
  1. Remove the oil pressure switch assembly (Click here).

  1. A222343E01
    Install an oil pressure gauge.
    Text in Illustration 
    *1
    Oil Pressure Gauge

  1. Warm up the engine.

  1. Measure the oil pressure.

    Standard Oil Pressure:
    Condition
    Specified Condition
    Idle
    29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
    3000 rpm
    160 to 490 kPa (1.6 to 5.0 kgf/cm2, 23 to 71 psi)

    If the oil pressure is not as specified, check the oil pump (Click here).

  1. Remove the oil pressure gauge.

  1. Install the oil pressure switch assembly (Click here).

← INSTALLATION (from Aug 2014)COMPONENTS (from Aug 2013) →