INSPECTION
Inspection · Vehicles built from Aug 2013
| INSPECT REAR DIFFERENTIAL LOCK POSITION SWITCH |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
1 (GND) - 2 (+B)
Pushed
Below 1 Ω
Released
100 kΩ or higher
Text in Illustration *a
Component without harness connected
(Rear Differential Lock Position Switch)
*b
Pushed
*c
Released
- If the result is not as specified, replace the rear differential lock position switch.
