2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT HEATER SWITCH ASSEMBLY

E166833E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (+S) - 3 (E)
    Heater switch assembly off
    10 kΩ or higher
    Heater switch assembly on
    Below 1 Ω

  1. Apply battery voltage to the connector and check the LED illumination.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 5 (ILL+)
    Battery negative (-) → Terminal 4 (ILL-)
    LED illuminates

    Text in Illustration 
    *a
    Component without harness connected
    (Heater Switch Assembly)
    If the result is not as specified, there may be a malfunction in the heater switch assembly.


INSPECT IDLE UP SWITCH

E166833E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (SW) - 3 (E)
    Idle up switch off
    10 kΩ or higher
    Idle up switch on
    Below 1 Ω

  1. Apply battery voltage to the connector and check the LED illumination.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 5 (ILL+)
    Battery negative (-) → Terminal 4 (ILL-)
    LED illuminates

    Text in Illustration 
    *a
    Component without harness connected
    (Idle Up Switch)
    If the result is not as specified, there may be a malfunction in the idle up switch.

← REMOVAL (from Aug 2014)INSTALLATION (Aug 2013 – Jul 2014) →