2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY

  1. E283079
    Detach the 4 clips.

  1. Disconnect the connector and remove the integration control and panel assembly.


2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/o Display)

B356214
  1. Detach the 10 clips and remove the center instrument cluster finish panel.

  1. Disconnect each connector.


3. REMOVE NAVIGATION RECEIVER ASSEMBLY (w/ Navigation System)

4. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY (w/o Display)

E282729
  1. Using a screwdriver, detach the 4 claws and remove the hazard warning signal switch assembly.


5. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY (w/ Display)

E282728
  1. Disconnect the connector.

  1. Using a screwdriver, detach the 2 claws and remove the hazard warning signal switch assembly.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →