2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSTALL HEADLIGHT ASSEMBLY LH
  1. Put protective tape around the headlight assembly LH.

  1. Connect each connector.

  1. Install the headlight assembly LH with the bolt and 3 screws.

    Torque:
    for Bolt:
    5.6 N*m{ 57 kgf*cm , 50 in.*lbf }


    E282523E02
    Text in Illustration 
    *1
    Protective Tape
    *2
    Bolt
    *3
    Screw
    -
    -

  1. Install the clip.


2. INSTALL FRONT FENDER SIDE PANEL PROTECTOR LH
  1. Attach the 3 clips to install the front fender side panel protector LH.


3. INSTALL FRONT BUMPER COVER
(Click here)

4. ADJUST HEADLIGHT AIMING
(Click here)

5. ADJUST FOG LIGHT AIMING
(Click here)
← REASSEMBLY (from Aug 2013)COMPONENTS (from Aug 2013) →