2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE NO. 2 HEADLIGHT BULB

  1. E282545
    Disconnect the connector.

  1. E282546
    Turn the No. 2 headlight bulb in the direction indicated by the arrow to remove it.

    NOTICE:
    Do not touch the glass part of the bulb.


2. REMOVE FRONT TURN SIGNAL LIGHT BULB

  1. E282548
    Turn the front turn signal light bulb socket with the front turn signal light bulb in the direction indicated by the arrow to disconnect them as a unit.

  1. E282550
    Remove the front turn signal light bulb from the front turn signal light bulb socket.


3. REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH

  1. E282552
    Turn the headlight light control ECU sub-assembly LH in the direction indicated by the arrow to disconnect it.

  1. E282553
    Disconnect the connector and remove the headlight light control ECU sub-assembly LH.


4. REMOVE HEADLIGHT SOCKET COVER

  1. E282554
    Remove the screw.

  1. Detach the guide and remove the headlight socket cover.


5. REMOVE HEADLIGHT GASKET

  1. E282555
    Remove the headlight gasket from the headlight socket cover.


6. REMOVE HEADLIGHT LEVELING MOTOR LH

  1. E283841
    Disconnect the connector.

  1. Detach the claw and rotate the headlight leveling motor LH in the direction of the arrow shown in the illustration.

    HINT:
    For the headlight leveling motor RH, rotate it in the opposite direction of the arrow shown in the illustration before pulling it out.

  1. Hold the LED unit in place by hand, and then pull out the end of the headlight leveling motor LH to disconnect it from the LED unit and remove the headlight leveling motor LH.

    E283089E01

    Text in Illustration 
    *1
    LED Unit
    *2
    End of Headlight Leveling Motor LH


7. REMOVE HEADLIGHT LEVELING MOTOR BASE PACKING

  1. E282556
    Remove the headlight leveling motor base packing from the headlight unit LH.


8. REMOVE FRONT BUMPER BAR REINFORCEMENT LH

  1. E282540
    Remove the 2 screws and front bumper bar reinforcement LH.


9. REMOVE FRONT BUMPER BAR REINFORCEMENT LH

  1. E282541
    Remove the 2 screws and front bumper bar reinforcement LH.

← REMOVAL (from Aug 2013)ADJUSTMENT (from Aug 2013) →