TRC OFF Indicator Light Remains ON
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The skid control ECU is connected to the combination meter via the CAN communication system.Pressing the VSC OFF switch turns off traction control and pressing and holding this switch turns off traction and VSC controls. If traction control turns off, the TRC OFF indicator light comes on.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform calibration (Click here).
- As there may be malfunctions in the transfer system related to when the transfer operates in L4, check the transfer system first (Click here).
- When replacing the brake actuator assembly, perform calibration (Click here).
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (for LHD without Entry and Start System: Click here, for RHD without Entry and Start System: Click here).
Result Result
Proceed to
DTC not output
A
DTC output
for LHD without Entry and Start System
B
DTC output
for RHD without Entry and Start System
C
|
|
||||
|
|
||||
| A | |
| 2. INSPECT VSC OFF SWITCH |
Remove the VSC OFF switch (Click here).
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
6 - 3
Switch is not pushed
10 kΩ or higher
Switch is pushed
Below 1 Ω
Text in Illustration *a
Component without harness connected
(VSC OFF Switch)
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH) |
Disconnect the A6 skid control ECU connector.
Disconnect the G9 VSC OFF switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A6-30 (CSW) - G9-6
Always
Below 1 Ω
A6-30 (CSW) - Body ground
Always
10 kΩ or higher
G9-3 - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 4. READ VALUE USING INTELLIGENT TESTER (TRC/VSC OFF MODE) |
Turn the ignition switch off.
Connect the Intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
TRC/VSC Off Mode
TRC/VSC off mode/ Normal, TRC OFF or VSC OFF
Normal: Normal mode
TRC OFF: TRC OFF mode
VSC OFF: VSC OFF mode
-
Check that the mode display changes according to VSC OFF switch operation.
- OK:
- Display changes according to switch operation.
|
|
||||
| OK | ||
| ||
