2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Navigation Receiver Assembly Power Source Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit provides power to the navigation receiver assembly.

WIRING DIAGRAM

E282609E06

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - BATTERY AND BODY GROUND)

  1. E280967E05
    Disconnect the navigation receiver assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H54-7 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    H54-4 (+B1) - Body ground
    Always
    11 to 14 V
    H54-3 (ACC1) - Body ground
    Engine switch on (ACC)
    11 to 14 V
    H56-1 (IG) - Body ground
    Engine switch on (IG)
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Navigation Receiver Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Stereo Component Amplifier Power Source Circuit (from Aug 2014)Navigation Receiver Assembly Power Source Circuit (from Aug 2014) →