2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT ROOM LIGHT SWITCH ASSEMBLY

  1. E198481E01
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (UP) - 4 (E)
    Light control switch off
    10 kΩ or higher
    Light control switch UP
    Below 1 Ω
    2 (DOWN) - 4 (E)
    Light control switch off
    10 kΩ or higher
    Light control switch DOWN
    Below 1 Ω

  1. Apply battery voltage to the connector and check the LED illumination.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 5 (ILL+)
    Battery negative (-) → Terminal 1 (E)
    LED illuminates

    If the result is not as specified, replace the room light switch assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Room Light Switch)

← REMOVAL (from Aug 2014)INSTALLATION (Aug 2013 – Jul 2014) →