2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. REMOVE DOOR SCUFF PLATE ASSEMBLY LH

B238732E01
  1. Put protective tape around the door scuff plate.

  1. Using a screwdriver, detach the 4 clips, 10 claws and 2 guides and remove the door scuff plate.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


2. REMOVE COWL SIDE TRIM BOARD LH

B238734
  1. Remove the clip.

  1. Detach the clip and claw and remove the cowl side trim board.


3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

B356218
  1. for LHD:

    1. Remove the screw.

    2. Detach the 2 clips and 2 guides and remove the No. 1 instrument panel under cover.

    3. Disconnect each connector.

  1. B298554
    for RHD:

    1. Remove the screw.

    2. Detach the 3 clips and 2 guides and remove the No. 1 instrument panel under cover.

    3. Disconnect each connector.


4. REMOVE INSTRUMENT SIDE PANEL LH

B238205E01
  1. Put protective tape around the instrument side panel.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 5 clips, claw and 3 guides and remove the instrument side panel.


5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

B238207E01
  1. Put protective tape around the instrument cluster finish panel ornament.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 3 clips and remove the instrument cluster finish panel ornament.


6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for LHD)

B238214
  1. Detach the 4 clips.

  1. Disconnect each connector and remove the instrument panel finish panel.


7. REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

B238239
  1. Detach the 4 clips.

  1. Disconnect each connector and remove the instrument panel finish plate garnish.


8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

B238214
  1. Detach the 4 clips.

  1. Disconnect each connector and remove the instrument panel finish panel.


9. REMOVE HEATER SWITCH ASSEMBLY (for LHD)

  1. E199780
    Detach the 2 claws and remove the switch.


10. REMOVE HEATER SWITCH ASSEMBLY (for RHD)

  1. E199781
    Detach the 2 claws and remove the switch.


11. REMOVE IDLE UP SWITCH (for LHD)

  1. E199780
    Detach the 2 claws and remove the switch.


12. REMOVE IDLE UP SWITCH (for RHD)

  1. E199781
    Detach the 2 claws and remove the switch.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →