2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT HEADLIGHT RELAY

  1. E282732
    Remove the 2 headlight relays from the engine room relay box.

  1. E277745E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the headlight relay.

  1. Install the 2 headlight relays to the engine room relay box.


INSPECT REAR FOG LIGHT RELAY

  1. E282733
    Remove the rear fog light relay from the engine room relay box.

  1. E277744E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the rear fog light relay.

  1. Install the rear fog light relay to the engine room relay box.


INSPECT NO. 1 DAY TIME RUNNING LIGHT RELAY

  1. E282734
    Remove the No. 1 day time running light relay from the No. 3 engine room relay box.

  1. E277744E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the No. 1 day time running light relay.

  1. Install the No. 1 day time running light relay to the No. 3 engine room relay box.

← INSTALLATION (from Aug 2014)PARTS LOCATION (from Aug 2013) →