2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE REAR ENGINE UNDER COVER ASSEMBLY
  1. Remove the 4 bolts and rear engine under cover.


2. DRAIN ENGINE OIL
  1. Remove the oil filler cap.

  1. Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.

  1. Wipe the oil pan and drain plug.

  1. Install a new gasket and the oil pan drain plug.

    Torque:
    34 N*m{ 347 kgf*cm , 25 ft.*lbf }


3. REMOVE ENGINE OIL LEVEL SENSOR

  1. A223501
    Disconnect the engine oil level sensor connector.

  1. Remove the 4 bolts, engine oil level sensor.

  1. Cut away part of the gasket and remove the gasket from the engine oil level sensor.

    HINT:
    Remove only the outer part of the gasket.

← COMPONENTS (from Aug 2013)INSPECTION (from Aug 2013) →