INSPECTION
Inspection · Vehicles built from Aug 2013
| INSPECT CENTER CLUSTER MODULE SWITCH (HEIGHT CONTROL SWITCH) |
Measure the resistance according to the values in the table below.

- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
7 (LO) - 24 (E)
"Down" pressed
Below 1 Ω
"Up" pressed
10 kΩ or higher
6 (HI) - 24 (E)
"Down" pressed
10 kΩ or higher
"Up" pressed
Below 1 Ω
If the result is not as specified, replace the center cluster module switch (height control switch).Text in Illustration *a
Component without harness connected
(Height Control Switch)
