2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

B15F7 Certification ECU Vehicle Information Reading/Writing Process Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the audio and visual system vehicle customization screen.

HINT:
The certification ECU (smart key ECU assembly) controls the entry and start system (for Entry Function) related items that are customizable via the radio and display receiver assembly screen.

DTC Code
DTC Detection Condition
Trouble Area
B15F7
Certification ECU (smart key ECU assembly) vehicle setting processing error.
  1. CAN communication system
  2. Entry and start system (for Entry Function)
  3. Certification ECU (smart key ECU assembly)
  4. Radio and display receiver assembly

INSPECTION PROCEDURE

HINT:
When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Use the GTS to check if the CAN communication system is functioning normally.

    1. for LHD with Entry and Start System: Click here
    2. for LHD without Entry and Start System: Click here
    3. for RHD with Entry and Start System: Click here
    4. for RHD without Entry and Start System: Click here

    OK:
    CAN communication DTCs are not output.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for LHD with Entry and Start System)
    B
    NG (for LHD without Entry and Start System)
    C
    NG (for RHD with Entry and Start System)
    D
    NG (for RHD without Entry and Start System)
    E



B
GO TO CAN COMMUNICATION SYSTEM (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (Click here)

D
GO TO CAN COMMUNICATION SYSTEM (Click here)

E
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2. CHECK ENTRY AND START SYSTEM (for Entry Function)
  1. Check if the entry and start system (for entry function) is malfunctioning (Click here).

    HINT:
    Customization may not be possible depending on the malfunction in the entry and start system (for entry function).

    OK:
    No malfunctions are present in the entry and start system (for entry function).



NG
GO TO ENTRY AND START SYSTEM (Click here)
OK


3. CHECK CUSTOMIZE ITEMS
  1. Display the "Vehicle Customization" screen.

  1. Make a note of the customizable items for each certification ECU (smart key ECU assembly) related system.

    HINT:
    These items shown as customizable via the audio and visual system vehicle customization screen can also be changed manually. In a following step, a manual procedure will be used.

    1. Check the customize parameters list for the entry and start system (for entry function) related items that can be customized via the radio and display receiver assembly screen (Click here).

  1. Manually change and confirm that it was possible to successfully change the settings of the customize parameters for each system that are available for customization via the radio and display receiver assembly screen.

    OK:
    The items available for customization via the radio and display receiver assembly screen can be customized successfully using the manual procedure.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)


← B15F7 Certification ECU Vehicle Information Reading/Writing Process Malfunction (Aug 2013 – Jul 2014)B15F8 Driver Seat ECU Vehicle Information Reading/Writing Process Malfunction (Aug 2013 – Jul 2014) →