2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

DATA LIST / ACTIVE TEST

System information · Vehicles built from Aug 2013


DATA LIST

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the GTS to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Main Body / Data List.

  5. Read the Data List according to the display on the GTS.

Main Body 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Back Door Courtesy SW
Back door courtesy switch signal / ON or OFF
ON: Back door open
OFF: Back door closed
-
← DTC CHECK / CLEAR (from Aug 2014)DIAGNOSTIC TROUBLE CODE CHART (Aug 2013 – Jul 2014) →